» Making 2.4 GHz WiFi Antenna Dipole (Omni Antenna 2,4 Ghz)
Here's an example in the manufacture of 2.4 GHz WiFi antenna dipole. For readers who wish to build this antenna HOTSPOT worth a try in order to suppress the price compared to buying a factory-built antenna.
A. Material
1. RG 6 Coaxial
2. Pralon ¾ inch pipe
3. AC ¼ inch copper pipe x 0.56
4. M40-F type connectors as much as 1 piece
5. tin solder
6. glue stick
7. copper plate
8. Nail Rivet
B. equipment
1. Hand drilling machine
2. pliers Rivet
3. solder
4. Glue Gun
5. combination pliers
6. Long nose pliers
7. cutting pliers
8. Meter 3 M
C. Working drawings
Driven / horn
2. Omni Antenna Circuit
D. step Work
A. Driven / Horn
* Cut the copper AC pipe diameter 1/4 "long 47 mm
* Cut along the 67mm Coaxial RG 6, then discard the outer skin
* Peel the skin of the inside at both ends of the RG 6 Coaxial along the 10 mm
* Enter peeling RG 6 Coaxial copper pipe into the AC
* Perform a job point 1.a s.d. point 1.d 25 times.
* Connect the result of point 1.e soldered manner and interspersed between the positive and ground wires cables, note the picture
* Perform a job on top of that connected all
* After all connected all, in the end driven / horn mounted stub ends of the stub and the other is mounted M40-F type connector, look at the picture
2. finishing
* Cut pipe 150 cm long pralon
* Enter driven / horn that was made at the point 1 into these modified pipes and M40-F type connectors are outside of the plastic gutter. (see work)
* Cover the top with a cover / hubcap paralon
* Use a glue gun to attach the M40-F type connector to attach it firmly at the end of the plastic gutter.
No comments